In this article we will look at the reasons why a garage door spring breaks.
What causes garage door spring to break.
Garage door springs will not last long enough before they break if saving money was an important consideration when buying them.
This is the 1 reason why garage door springs fail or break.
When the garage door is lowered the springs gain tension.
As a result most garage door springs break when the door is down.
On the opposite you will find a winding cone.
Excessive wear and tear.
The spring can break for a handful of reasons some which are preventable.
Purchasing a single spring where two are needed and other cost saving schemes could.
As such they have a stationery cone situated at one end.
A typical garage door would weigh about 130 400 pounds and thus the need for a garage door spring that offsets the weight of its door while also lifting it for you so you won t have difficulty opening and closing the garage door every time you need to.
When raising the garage door tension is released and the spring assists with the lifting.
The torsion spring plays a critical role in the functionality of the door.
Top reasons why garage door springs break.
Impact damage to the garage door.
A cycle is when the garage door goes up and then goes back.
It facilitates the opening and closing of the garage door by allowing it to raise and lower.
Weight added to the door after its installation.
A torsion spring on average can last for 10k cycles.
Its important to note your garage door springs have most tension when the garage door is in the closed position.
The springs unwind as the garage door is being raised.
Sustained exposure to cold temperatures.
When a garage door torsion spring fails or breaks it would be rather important to have a new spring installed as soon as possible.
The average properly installed torsion springs will last for approximately 10 000 cycles.
It is tempting to purchase cheap door springs to everyone but it is one of the leading causes as to why springs break regularly.