Yes you can install just about any type of flooring over a radiant heat system but i would not recommend any type of vinyl flooring.
What vinyl plank can use over radiant heat.
Plus i m sick of tiling do i need to put thinset over the radiant heat coils or can i put the vinyl flooring right on top of the heat coils and keep under 80 degrees.
And also you want to check with the manufacturer because installing some floor over a radiant heat system will void the warranty.
It sounds like vinyl plank flooring would be a lot quicker and easier to install in the remainder of my bathroom.
Radiant heating can be installed under resilient floorings such as sheet vinyl tile vinyl and luxury vinyl plank.
But think about it with good common sense.
Not only is stone safe to use over radiant heating but it also retains heat for a longer period than tile after system shut off.
Keep in mind that minor gaping between planks during the heating season is a normal occurrence with laminate over a radiant heated sub floor.
It should also include a surface temperature probe as well as thermostat controls.
Since most luxury vinyl tile lvt manufacturer s set a maximum temperature for radiant floor heating the system should have little to no effect on the rubber cork backing.
The radiant heating system must be designed specifically for use with laminate flooring.
Then use a marker to indicate how the heating element will be laid out per your custom installation plan.
The following list contains important information about installing our laminate flooring over radiant heat so don t skip ahead.
Check the manufacturer s installation instructions for maximum temperatures.
Therefore if you are considering radiant heating with vinyl planks as the sole source of heat carry out a heat loss calculation first to ensure the heated floor will be providing you with sufficient amount of heat.
The temperature of the heating system with vinyl should not exceed 81 f.
Never raise the flooring surface temperature above 82 degrees.
Can vinyl plank be installed over radiant heat.
Pre attached backing can act as an insulating layer though meaning it can prevent the radiant heating from efficiently directing heat up through the floor.
Electric underfloor heating is suitable under vinyl floors.
Test the heating element.
Once installation is finished do not change radiant heat for at least another 48 hours.
Using a digital ohmmeter test the heating element to be sure it is fully operational.